Specially formulated for porcelain paving ProJoint™ PORCELAIN™ Grout has been developed for joint widths of 2-20mm. Ideal for internal and external use. Using anti mould growth technology with added silicone ProJoint™ PORCELAIN™ Grout repels water from the surface of the grout, while allowing vapour to pass through.
The ProJoint™ PORCELAIN™ Grout is supplied in a bag to allow
the branded bucket/tub to be used as the ideal mixing vessel.
Available in three colours - neutral (buff), mid grey and black - ProJoint™ PORCELAIN™ Grout offers a fast application product with professional results.
Developed for joint widths of 2 to 20mm
Suitable for external and internal use
Ready to use, two 10kg bags supplied in its own mixing tub
Ensure that the paving is firmly fixed and the joints are clean, free of dust, excess adhesive, bedding mortar or any contamination. Do not use in wet weather and do not use if frost is forecast in the next 24 hours. Suitable for use in temperatures between 3°C and 25°C. Do not apply to areas in direct sunlight or to substrates that are hot.
A grout film and/or pigment stains, especially with dark colours, may remain on paving after jointing. Follow the paving manufacturer’s recommendations. A trial grouting area is recommended to check suitability. Only clean water and clean tools must be used for grouting and final cleaning. Never add water or fresh grout powder to a grout mix which has already started to set.
ProJoint™ Porcelain Grout should be mixed with 3 litres of cold clean water per 10kg bag. Remove the bag from the bucket and add the water to the mixing container. Add the powder slowly and mix using a plasterers' whisk until a smooth creamy consistency is reached. Mix for 2 minutes, allow standing for 2 minutes then re-mix. This process allows the polymer additives to dissolve and activate.
Use a rubber float to work the grout deeply into the joints until flush with the paving. Excess grout should be removed as work proceeds and any final residues left on the tile face can be removed by wiping off with a damp sponge up to 30 minutes after application. Ensure you have plenty of clean water for removing grout whilst wet/damp. Any dry film remaining on the surface can be removed by polishing off with a dry cloth when the grout has hardened in the joints. Freshly grouted joints should be kept damp when working outdoors using a fine mist spray. The pot life of the mixed grout is approximately 60 minutes at 20°C. NOTE: the grout will be considerably lighter in colour once dry.
Cure times are dependent on temperature and humidity but as a guide can accept foot traffic after 3 hours at 20°C and full cure after 72 hours at 20°C. All tools should be washed out with water immediately after use. Waste material should not be emptied into drainage systems.
Approximate coverage per 20kg kit:
© Nexus® Professional Surfacing Systems
The technical information given on our products is based on data obtained by our own research and is considered accurate. However no liability is accepted for any loss or damage arising directly or indirectly from the use of our products, or from the information given in publications. Prospective users should therefore satisfy themselves by appropriate trials that the product is suitable for the intended use.