Scatter™ is a resin bonded stone surfacing system. It is used for overlaying asphalt or concrete to create an attractive and hard wearing surface which has very good anti slip and anti skid properties.
Like DriveDash®, Scatter™ resin bonded gravel is used widely on large and small driveways, paths, access roads, landscaping and commercial schemes.
Its cost effectiveness and fast application makes it suitable for large areas. As surfaces have to be smooth and in relatively good condition it tends to be used to overlay new surfaces rather than renovating old.
Very cost effective
Very attractive, natural and modern
Fast & simple installation
Very durable and hardwearing
High friction giving high slip resistance
Scatter™ is laid by mixing a a 2-part resin which is then spread out evenly over the treatment area and then broadcast with a 1-3mm aggregate. Once the resin has cured, the excess aggregate is removed by brushing or vacuuming and the resultant finish is a thin layer of aggregate fully bonded to the surface.
The system is very fast to lay and requires no specialist equipment. The following diagram shows a cross
section of the product:
|Area prepared and tools||Adding hardener to resin||Mixing resin & hardener||Applying resin||Scattering aggregate||Sweeping off excess|
The images show that Scatter™ is very straight forward to lay and excellent results can be obtained very quickly. We also offer training if required and operate our approved installer scheme. Please call to find out more.
A wide range of aggregate colours and finishes are available for use with the system; If you have a surfacing requirement then contact us for advice and a quotation. We can advise on the most suitable product, coverage rates and laying methods depending on your requirements.
Full product information on the Scatter™ system is shown in page 42. Click to view the brochure:
|© Nexus® Professional Surfacing Systems
The technical information given on our products is based on data obtained by our own research and is considered accurate. However no liability is accepted for any loss or damage arising directly or indirectly from the use of our products, or from the information given in publications. Prospective users should therefore satisfy themselves by appropriate trials that the product is suitable for the intended use.